HE05256: PART : THREAD/TAP RECOMMENDED VALUE ERROR IN INCORRECT UNITS

APAR status

• Closed as program error.

Error description

• When Thread/Tap definition is applied to a hole (pocket
  feature) with incorrect diameter, based on the standard,
  recommended diameter is reported in MM when Inches is
  specified as the current Length unit.
  .
  Scenario:
  1. Place an xls thread table into CATIA install \standard
  dir.
  2. Create a simple part
  3. Thread/Tap Command. Specify Lateral Face and Limit Face on
  the hole in part.
  4. Change Type to the specific table
  5. Select a thread.
  ==> the warning message displays to say: "Feature Definition
  Error: ... Value recommended by your standard is 10.5842"
  The recommended value is in MM, regardless of Length unit
  defined in CATSettings. Should report recommended value of
  .4167
  .
  

Local fix

• empty
  

Problem summary

• When Thread/Tap definition is applied to a hole (pocket
  feature) with incorrect diameter, based on the standard,
  recommended diameter is reported in MM when Inches is
  specified as the current Length unit.
  .
  Scenario:
  1. Place an xls thread table into CATIA install \standard
  dir.
  2. Create a simple part
  3. Thread/Tap Command. Specify Lateral Face and Limit Face on
  the hole in part.
  4. Change Type to the specific table
  5. Select a thread.
  ==> the warning message displays to say: "Feature Definition
  Error: ... Value recommended by your standard is 10.5842"
  The recommended value is in MM, regardless of Length unit
  defined in CATSettings. Should report recommended value of
  .4167
  .
  

Problem conclusion

• THIS PROBLEM WILL BE FIXED ON CATIA VERSION V5R22 GA level.
  NOTE THAT THIS PROBLEM WILL ALSO BE FIXED ON V5R21 SP1.
  .
  Additional Closure Information:
  Technical explanation of the defect:
  The warning message does not take into account the unit used
  in the session and the reference file
  .
  Technical explanation of the correction:
  The problem has been corrected in modifying the warning
  message in order to take into account the unit of the
  reference file.
  .
  Possible by-pass and/or correction limitation:
  No possible by-pass but the problem is fixed now.
  .
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 WIN 64

• Fixed component ID

  569165000

Applicable component levels

• R521 PSN SP52101

     UP11/07/18 I 1000