HE03849: ENDCUT CREATED FROM SOLID FEATURE IS VISIBLE ALTHOUGH IT IS DISP LAY AS HIDE IN THE SPECIFICATION TREE

APAR status

• Closed as Permanent restriction.

Error description

• Scenario:
  1. Start CATIA V5
  2. Create a new Endcut for say T profile, and end result of
  the endcut should be Part Design feature
  2. Add this test_endcut UDF from test_tee.CATPart to the
  StructureDetailingFeatures.catalog under Detailing features >
  Endcuts > Tee > Snipe > Custom
  3. Save the catalog and close it
  4. Create a new Design unit and  create a new Deck with
  stiffener inside it.
  5. Run the Endcut command in the Structure Detail object
  Design WB
  6. Select the stiffener
  7. MB3 on one of the lines in the edition window (Start or
  End) > Define EndCut > More...
  8. Select Snipe > test_endcut and click OK
  9. Click OK
  CONCERN:
  Endcut is visible although it is Hide in the specification
  tree
  Expected result: the Endcut should  not be visible.
  

Local fix

• empty
  

Problem summary

• Scenario:
  1. Start CATIA V5
  2. Create a new Endcut for say T profile, and end result of
  the endcut should be Part Design feature
  2. Add this test_endcut UDF from test_tee.CATPart to the
  StructureDetailingFeatures.catalog under Detailing features >
  Endcuts > Tee > Snipe > Custom
  3. Save the catalog and close it
  4. Create a new Design unit and  create a new Deck with
  stiffener inside it.
  5. Run the Endcut command in the Structure Detail object
  Design WB
  6. Select the stiffener
  7. MB3 on one of the lines in the edition window (Start or
  End) > Define EndCut > More...
  8. Select Snipe > test_endcut and click OK
  9. Click OK
  CONCERN:
  Endcut is visible although it is Hide in the specification
  tree
  Expected result: the Endcut should  not be visible.
  

Problem conclusion

• THIS PROBLEM IS PERMANENT RESTRICTION IN CATIA V5.
  Additional Closure Information:
  UDF created in PartDesign when instantiated for endcut it is
  not behaving properly. Show/Un
  show, applying color, "Reframe on" etc are not working
  correctly.
  Reason:
  Interactively when Part Design UDF is instantiated in GSD or
  Shipbuilding Workbench, it throws
  the error. And theory of Partdesign follows order geometrical
  set. Programmatically the same
  check is not done while instantiating endcut. So this problem
  cannot be fixed.
  Bypass:
  If UDF is created with GSD volume then it works correct.
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels