HD98608: ERROR 00904 WHEN CLOSING SMARTEAM IF VIEWER TAB IS ACTIVE.

APAR status

• Closed as unreproducible in next release.

Error description

• Scenario :-
  1) Start Smarteam Editor V5 R19 SP6 with Smdemo database.
  2) Add any solidworks assembly to any test project.
  3) Select Lifecycle --> Check In.
  4) Select Lifecycle ---> Release.
  5) Click on the viewer tab.
  6) Close the Smarteam Editor.
  Result ==> An error message is displayed 00904.
  Expected Result ==> The error message shouldn't be displayed.
  

Local fix

• empty
  

Problem summary

• Scenario :-
  1) Start Smarteam Editor V5 R19 SP6 with Smdemo database.
  2) Add any solidworks assembly to any test project.
  3) Select Lifecycle --> Check In.
  4) Select Lifecycle ---> Release.
  5) Click on the viewer tab.
  6) Close the Smarteam Editor.
  Result ==> An error message is displayed 00904.
  Expected Result ==> The error message shouldn't be displayed.
  

Problem conclusion

• THE PROBLEM WAS SUBMITTED ON :
      I-PLM Collaborative Innovation VERSION V5R19.
  THIS PROBLEM IS NOT REPRODUCIBLE ON :
  I-PLM Collaborative Innovation VERSION V5R21 GA level
  Additional Closure Information:
  This issue has been fixed on Smarteam V5 R20 SP4.
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  SMARTEAM NT>XP

• Fixed component ID

  569199970

Applicable component levels

• R521 PSN

     UP