HD97026: ICEM SHAPE DESIGN: ICEM SHAPE DESIGN PERFORMACE OF THE COMPUTATI ON OF AN ADVANCE FILLET IS TOO LONG

APAR status

• Closed as Permanent restriction.

Error description

• The performance of small advanced fillets is too bad. The
  computation time sometimes exceeds several minutes.
  

Local fix

• empty
  

Problem summary

• The performance of small advanced fillets is too bad. The
  computation time sometimes exceeds several minutes.
  

Problem conclusion

• Please read through the following Points carefully:
  1. Performance in general has been improved (especially the
  "S" part of the example), but the PRS closure type is set
  because of the following points:
  2. Performance with option "automatic" is still much slower
  than in Surf. Reason: With automatic it is tried to achieve a
  result with the lowest order possible. This costs time. When
  settings are set like the are in Surf (switch off automatic,
  set order to "Fix: 7"), the performance is comparable).
  3. The data example can't be trimmed any longer. Reason: The
  radius of 0.26 is too big. See attached CATPart
  PBI_01363-trim-not-possible.CATPart and attached jpg
  Fillet-trim-no-possible.jpg. The result is therefore self
  intersecting, and such results can't trim the supports.
  Same is valid in Surf, there also face problems occur.
  Swinging surfaces exist, showing that the radius is too big.
  Additional Closure Information:
  Please read through the following Points carefully:
  1. Performance in general has been improved (especially the
  "S" part of the example), but the PRS closure type is set
  because of the following points:
  2. Performance with option "automatic" is still much slower
  than in Surf. Reason: With automatic it is tried to achieve a
  result with the lowest order possible. This costs time. When
  settings are set like the are in Surf (switch off automatic,
  set order to "Fix: 7"), the performance is comparable).
  3. The data example can't be trimmed any longer. Reason: The
  radius of 0.26 is too big. See attached CATPart
  PBI_01363-trim-not-possible.CATPart and attached jpg
  Fillet-trim-no-possible.jpg. The result is therefore self
  intersecting, and such results can't trim the supports.
  Same is valid in Surf, there also face problems occur.
  Swinging surfaces exist, showing that the radius is too big.
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels