HD96808: MACHINING (AMG) :GROOVE MILLING SPAWNS A KNOWLEDGE REPORT PANEL CATIA V5 / V5R19 SP5 / WINXP

APAR status

• Closed as unreproducible in next release.

Error description

• PROBLEM DESCRIPTION:
  This is data specific problem
  1.Open a specific CATProcess
  2.Expand the PPR Tree to the Machine Operations level
  3.Recompute the tool path for Manufacturing Program.1>Forced
  computation>OK
  4.Double click Groove Milling (computed) to activate
  5.Replay the Tool Path>Then OK out of Tool Path replay
  6.Attempt to add any type of Finishing Toolpath
  RESULT
  An error message is thrown with a Summary Error declarining:
  The Process\Groove Milling.x\MfgParameter.x\Maximum depth of
  cut parameter value is out of bounds.This is the problem.
  Picking another type of Finish Pass results in the same
  error.
  EXPECTED RESULT:
  Groove Milling Maching Operation should allow some type of
  finish pass to be added as spring pass when using Hard Top
  and Bottom and the cutter is the same width as the groove.
  

Local fix

• empty
  

Problem summary

• PROBLEM DESCRIPTION:
  This is data specific problem
  1.Open a specific CATProcess
  2.Expand the PPR Tree to the Machine Operations level
  3.Recompute the tool path for Manufacturing Program.1>Forced
  computation>OK
  4.Double click Groove Milling (computed) to activate
  5.Replay the Tool Path>Then OK out of Tool Path replay
  6.Attempt to add any type of Finishing Toolpath
  RESULT
  An error message is thrown with a Summary Error declarining:
  The Process\Groove Milling.x\MfgParameter.x\Maximum depth of
  cut parameter value is out of bounds.This is the problem.
  Picking another type of Finish Pass results in the same
  error.
  EXPECTED RESULT:
  Groove Milling Maching Operation should allow some type of
  finish pass to be added as spring pass when using Hard Top
  and Bottom and the cutter is the same width as the groove.
  

Problem conclusion

• THE PROBLEM WAS SUBMITTED ON :
  CATIA VERSION V5R19.
  THIS PROBLEM IS NOT REPRODUCIBLE ON :
  CATIA VERSION V5R21 GA level
  Additional Closure Information:
  INCIDENT DIAGNOSIS:
  Groove Milling spawns a Knowledge Report Panel for options
  related to "Mode" in "Finishing tab"
  CLOSURE DESCRIPTION:
  Problem is not reproduced on CATIA V5R21GA and Knowledge
  Report Panel does not come for options related to "Mode" in
  "Finishing tab"
  NOTE: FOR CATIA V5R20SP03
  Value of maximum depth of cut was compared again which was a
  wrong comparison hence out of bound error was coming. Now,
  this problem is corrected in code and knowledge report panel
  does not comes for options related to "Mode" in "Finishing
  tab".
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 NT>XP

• Fixed component ID

  569151000

Applicable component levels

• R521 PSN

     UP