HD93951: INTEROPV4/V5 : SPECIFIC CATIA V4 MODELS WITH CCV CURVES CANNOT B E MIGRATED TO CATIA V5

APAR status

• Closed as program error.

Error description

• Scenario:
  1) File / New Part
  2) File / Open the provided model
  3) Copy the CCV and paste into the new part
  -> The following message is displayed:
  The CATIA V4 curve *CCV1 -wsp *MASTER has not been pasted:
  An invalid internal gap between two curves is detected in
  wire:
  Correct this wire from input model.
  .
  Expected result:
  The CCVs are healed to the point where their conversion to V5
  does not contain any gaps
  .
  

Local fix

• empty
  

Problem summary

• Scenario:
  1) File / New Part
  2) File / Open the provided model
  3) Copy the CCV and paste into the new part
  -> The following message is displayed:
  The CATIA V4 curve *CCV1 -wsp *MASTER has not been pasted:
  An invalid internal gap between two curves is detected in
  wire:
  Correct this wire from input model.
  .
  Expected result:
  The CCVs are healed to the point where their conversion to V5
  does not contain any gaps
  .
  

Problem conclusion

• NOTE THAT THIS PROBLEM WILL ALSO BE FIXED ON V5R19 SP8.
  Additional Closure Information:
  THIS PROBLEM WILL BE FIXED AT:
  CATIA VERSION 5 RELEASE 21 GA LEVEL
  ALSO FIXED AT THE FOLLOWING LEVELS:
  V5R19SP08 AND V5R20SP02
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 NT>XP

• Fixed component ID

  569151000

Applicable component levels

• R519 PSN SP51908

     UP10/06/10 I 1000