HD90101: SW_DESIGN ABEND U0110 WITH MULTIPLE MODELS LOADED .

APAR status

• Closed as unreproducible in next release.

Error description

• Scenario:
  1.  RUN CATIA V4 with default AEC environment
  2.
  Load the model 1 provided as active
  3. Go into menu
  SW_DESIGN/Part/Modify/Geometry
  4. select green plate
  5.
  select the thickness icon (middle icon)
  6. enter a new plate
  thickness (e.g. 0.0200m)
  Observe that the plate is updated
  ok
  7. Load the model 2 as passive
  8. Go into menu
  SW_DESIGN/Part/Modify/Geometry
  9. select green plate (the one
  in active model)
  10. select the thickness icon (middle icon)
  RESULT : ABEND U110 occurs
  EXPECTED RESULT : The ABEND
  should not occur
  

Local fix

Problem summary

• Scenario:
  1.  RUN CATIA V4 with default AEC environment
  2. Load the model 1 provided as active
  3. Go into menu SW_DESIGN/Part/Modify/Geometry
  4. select green plate
  5. select the thickness icon (middle icon)
  6. enter a new plate thickness (e.g. 0.0200m)
    Observe that the plate is updated ok
  7. Load the model 2 as passive
  8. Go into menu SW_DESIGN/Part/Modify/Geometry
  9. select green plate (the one in active model)
  10. select the thickness icon (middle icon)
  RESULT : ABEND U110 occurs
  EXPECTED RESULT : The ABEND should not occur
  

Problem conclusion

• THE PROBLEM WAS SUBMITTED ON CATIAV425SP17
  THIS PROBLEM IS NOT REPRODUCIBLE ON CATIAV425SP19
  Additional Closure Information:
  .
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V4 AIX

• Fixed component ID

  562610000

Applicable component levels

• R425 PSN UH95319

     UP10/02/08 I 1000