HD88586: THERE IS NO WAY TO DISABLE A COMMAND IN CATIA .

APAR status

• Closed as Permanent restriction.

Error description

• SCENARIO:
  1.Create three parts ROOT, SOURCE,RESULT and create
  following structure in Portal
  _ SOURCE
  ROOT-|
  - RESULT
  2.Associate to SOURCE a CATPart containing
  two published bodies and an empty CATPart to RESULT.
  3.Load
  both DOCCADs in CATIA V5 in product mode, switch to Design
  Mode and Copy/Paste Special(as result with link) the
  Publications of SOURCE.
  4.Save the modifications and close all
  documents.
  5.Load the document of SOURCE in CatiaV5,switch to
  Design Mode and modify the geometry of one of the published
  entities.
  6.Save the modifications and close the
  document.
  7.Consequently, if we take a look at the Impact
  Graph, we can see that one of the Links is not
  synchronized.
  8.Then we open both DOCCADs, switch to Design
  Mode for RESULT only, be actived in part RESULT and try to
  update. We get the Warning.
  9.If we switch to Design Mode for
  both DOCCADs, update RESULT, switch to Visualization Mode for
  SOURCE only and Save
  .
  RESULT:
  The modifications seem to be
  taken into account, but the Impact Graph shows that the link
  is not synchronized, even if the links are OK in Database. The
  link should be synchronized.
  

Local fix

Problem summary

• SCENARIO:
  1.Create three parts ROOT, SOURCE,RESULT and create
  following structure in Portal
  _ SOURCE
  ROOT-|
  - RESULT
  2.Associate to SOURCE a CATPart containing
  two published bodies and an empty CATPart to RESULT.
  3.Load
  both DOCCADs in CATIA V5 in product mode, switch to Design
  Mode and Copy/Paste Special(as result with link) the
  Publications of SOURCE.
  4.Save the modifications and close all
  documents.
  5.Load the document of SOURCE in CatiaV5,switch to
  Design Mode and modify the geometry of one of the published
  entities.
  6.Save the modifications and close the
  document.
  7.Consequently, if we take a look at the Impact
  Graph, we can see that one of the Links is not
  synchronized.
  8.Then we open both DOCCADs, switch to Design
  Mode for RESULT only, be actived in part RESULT and try to
  update. We get the Warning.
  9.If we switch to Design Mode for
  both DOCCADs, update RESULT, switch to Visualization Mode for
  SOURCE only and Save
  .
  RESULT:
  The modifications seem to be
  taken into account, but the Impact Graph shows that the link
  is not synchronized, even if the links are OK in Database. The
  link should be synchronized.
  

Problem conclusion

• THIS PROBLEM IS PERMANENT RESTRICTION IN CATIA
  Additional
  Closure Information:
  Incident Diagnosis:
  There is no way to
  disable command for switching design mode to visualization
  mode in CATIA.
  .
  Reason:
  There is no such open architecture in
  CATIA that can allow users to disable/enable generic CATIA
  commands.
  .
  By-Pass:
  None
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels