HD74780: ASMD : CUTOUT : CUTOUT FAILS WITH TRIM BY THICK OPERATOR ERROR ON UPDATING R14 CATPART TO R18

APAR status

• Closed as unreproducible in next release.

Error description

• ASMD : CUTOUT : CUTOUT FAILS WITH TRIM BY
  THICK OPERATOR  ERROR ON UPDATING R14
  CATPART TO R18
  .
  SCENARIO:
  1. Open supplied CATPart.
  2. Double click on Sketch.1. Sketcher workbench
  appears
  3. Create a point and delete the same.
  4. Exit sketcher
  .
  OBSERVATION:
  Cutout.1 fails with error - Trim by Thick operator:
  The result cannot be assembled because of a
  current or permanent restriction. Change value or
  modify input body. Trim by Thick operator:
  Offset failed for sharp edges locally smooth (fading
  edges). Smooth input body in the neighborhood of
  these edges or trim tangency area.
  .
  

Local fix

Problem summary

• ASMD : CUTOUT : CUTOUT FAILS WITH TRIM BY THICK OPERATOR  ERROR
  ON UPDATING R14 CATPART TO R18
  ASMD : CUTOUT : CUTOUT FAILS WITH TRIM BY
  THICK OPERATOR  ERROR ON UPDATING R14
  CATPART TO R18
  .
  SCENARIO:
  1. Open supplied CATPart.
  2. Double click on Sketch.1. Sketcher workbench
  appears
  3. Create a point and delete the same.
  4. Exit sketcher
  .
  OBSERVATION:
  Cutout.1 fails with error - Trim by Thick operator:
  The result cannot be assembled because of a
  current or permanent restriction. Change value or
  modify input body. Trim by Thick operator:
  Offset failed for sharp edges locally smooth (fading
  edges). Smooth input body in the neighborhood of
  these edges or trim tangency area.
  .
  

Problem conclusion

Temporary fix

Comments

• THE PROBLEM WAS SUBMITTED ON CATIA
  VERSION 5 RELEASE 18.
  THIS PROBLEM IS NOT REPRODUCIBLE ON CATIA
  VERSION 5 RELEASE 20 GA LEVEL.
  V5R19SP01 AND ON V5R18SP06
  .
  Incident Diagnosis
  CUTOUT FAILS WITH TRIM BY THICK OPERATOR
  ERROR ON UPDATING R14 CATPART TO R18
  .
  For cutout failure : The cutout feature
  mapping fails for closed sketch. A closed
  sketch leads Instabilities (boundary
  conditions). So in order to by-pass these
  instabilities edited all cutout input sketches
  and remove the projections (borders
  edges) used to create a closed sketch.
  .
  Answer and By-Pass
  Modify the sketches used for all cutout to
  remove the projections, which form closed
  profile
  .
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 HP-UX

• Fixed component ID

  569102000

Applicable component levels

• R518 PSN SP51866

     UP08/08/19 I 1000