HD74496: PROJECTION OF 3D SECTION IN 2D NOT CORRECT

APAR status

• Closed as program error.

Error description

• Drafting (GenDraft)/.Projection of 3d section in 2D not correct
  
  Scenario:
  1 - Open CatiaV5R18SP03.
  2 - Open product1.catproduct.
  3 - Open drawing1.catdrawing.
  4 - Check the 2d view (not correct with the 3d section)
  5 - Make a modification of the 3d section in the 3d file,
      modify a little bit the heigh of the 3d section box.
  6 - 2D drawing shows wrong output.
  
  Problem:Updation of drawing gives wrong output.
  
  Expected result: Drawing should give correct output.
  

Local fix

Problem summary

• Projection of 3d section in 2D not correct
  Drafting (GenDraft)/.Projection of 3d section in 2D
  not correct
  .
  Scenario:
  1 - Open CatiaV5R18SP03.
  2 - Open product1.catproduct.
  3 - Open drawing1.catdrawing.
  4 - Check the 2d view (not correct with the 3d
  section)
  5 - Make a modification of the 3d section in the 3d
  file, modify a little bit the heigh of
  the 3d section box.
  6 - 2D drawing shows wrong output.
  .
  Problem:Updation of drawing gives wrong output.
  .
  Expected result: Drawing should give correct
  output.
  .
  .
  

Problem conclusion

• NOTE THAT THIS PROBLEM WILL ALSO BE FIXED
  ON V5R19SP01 AND ON V5R18SP06
  Incident Diagonosis
  .
  Drafting (GenDraft) / Projection of 3d section in 2D
  not correct
  .
  Correction Explanation
  There were changes done in past to swap the plane
  height & width while creating it.The issue was due
  to those changes.So those changes are reverted
  back to old code
  .
  .
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 NT>XP

• Fixed component ID

  569151000

Applicable component levels

• R518 PSN SP51866

     UP08/08/19 I 1000