HD74239: FTA/ INTERNAL ERROR IN MECHANICAL MODELLER

APAR status

• Closed as program error.

Error description

• FTA/ INTERNAL ERROR IN MECHANICAL MODELLER.
  .
  SCENARIO:
  .
  1. Start CATIA V5
  2. Open CATPart.
  3.  Expand the part body in the tree.
  4.  Double click on Hole.1.
  5.Change the diameter to .64in
  6.  Select ok.
  .
  RESULTS OBTAINED:
  Error message occurs, Internal Error in Mechanical
  Modeler.
  .
  EXPECTED RESULTS:
  Error message should not be obtained.
  .
  .
  

Local fix

Problem summary

• FTA/ INTERNAL ERROR IN MECHANICAL MODELLER
  FTA/ INTERNAL ERROR IN MECHANICAL MODELLER.
  .
  SCENARIO:
  .
  1. Start CATIA V5
  2. Open CATPart.
  3.  Expand the part body in the tree.
  4.  Double click on Hole.1.
  5.Change the diameter to .64in
  6.  Select ok.
  .
  RESULTS OBTAINED:
  Error message occurs, Internal Error in Mechanical
  Modeler.
  .
  EXPECTED RESULTS:
  Error message should not be obtained.
  .
  .
  

Problem conclusion

• THIS PROBLEM WILL BE FIXED ON CATIA VERSION
  5 RELEASE 20 GA LEVEL.
  NOTE THAT THIS PROBLEM WILL ALSO BE FIXED
  ON V5R19SP02
  INCIDENT DIAGNOSIS:
  .
  INTERNAL ERROR IN MECHANICAL MODELLER.
  .
  CORRECTION EXPLANATION:
  .
  The correction is done now.
  .
  The configuration of the Mirror was not set
  correctly resulting in the problem.
  After this correction, update the part. This would
  cause some FTA elements go in error.
  Re-connecting these FTA elements solves the
  problem.
  .
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 NT>XP

• Fixed component ID

  569151000

Applicable component levels

• R519 PSN SP51902

     UP08/11/07 I 1000