HD71760: WELDCUT WAS CREATED WITH AN ANGLED NOT A VERTICAL EDGE. MITER C UT IS FLIPPED OUT

APAR status

• Closed as program error.

Error description

• Weldcut was created with an angled not a vertical
  edge. Miter cut is flipped out
  Steps:
  Open attached CATProduct
  1. Activate the structure design work bench, click
  cutback->weld
  cut
  2. Select two beams, shape_770 and shape_1333
  The weld cut was created with an angled instead of
  a vertical edge.
  1. Click cutback, select miter cut. Select shape_927
  and shape_924.
  The result of Miter cut on a member is flipped over.
  Please refer the attachment for detail.
  .
  

Local fix

Problem summary

• Weldcut was created with an angled not a vertical edge. Miter c
  ut is flipped out
  Weldcut was created with an angled not a vertical
  edge. Miter cut is flipped out
  Steps:
  Open attached CATProduct
  1. Activate the structure design work bench, click
  cutback->weld
  cut
  2. Select two beams, shape_770 and shape_1333
  The weld cut was created with an angled instead of
  a vertical edge.
  1. Click cutback, select miter cut. Select shape_927
  and shape_924.
  The result of Miter cut on a member is flipped over.
  Please refer the attachment for detail.
  .
  

Problem conclusion

• THIS PROBLEM WILL BE FIXED ON CATIA VERSION
  5 RELEASE 19 GA LEVEL.
  NOTE THAT THIS PROBLEM WILL ALSO BE FIXED
  ON V5R18SP05
  1. For Weldcut use Cut by Plane mode
  2. For Mitercut, fix is delivered in R18Sp5 and
  R19GA. Reimplementd code
  .
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 NT>XP

• Fixed component ID

  569151000

Applicable component levels

• R517 PSN

     UP

• R518 PSN SP51805

     UP08/06/02 I 1000