HD59571: PART :CHAMFER IS NOT PROPERLY CREATED WITH SOME VALUES

APAR status

• Closed as suggestion for future release.

Error description

• Scenario :
  1. Start CATIA
  2. Open the provided CATPart
  3. Double click chamfer.2
  In chamfer definition set length to 0,499mm.
  the result is correct
  4. Change now chamfer length to 0,5mm.
  ==> the Result is incorrect. Same with 0,51 mm
  .
  .
  

Local fix

Problem summary

Problem conclusion

Temporary fix

Comments

• THIS APAR IS CONSIDERED AS A SUGGESTION
  FOR IMPROVEMENT WHICH CANNOT BE
  INCORPORATED IN VERSION V5R18
  PLEASE CONTACT YOUR SUPPORT DEPARTMENT IN
  ORDER TO OPEN A REQUIREMENT FORM.
  .
  Incident Diagnosis :
  Chamfer result is incorrect because definition
  values leads to a non supported configuration.
  Indeed, if length is above 0.5, the four chamfer
  ribbons are selfintersecting which each other,
  which is a current limitation.
  .
  Development Request Justification :
  Pyramidal configurations are not supported by the
  chamfer operator.
  .
  Answer and By-Pass
  Chamfer cannot be used to design pyramids.
  Please directly ask Part Design team to get
  information about features to use in such a purpose.
  .
  .
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels