HD56188: GENDRAFT / FRONT VIEW CANNOT BE CREATED AND ERROR MESSAGE OCCUR S

APAR status

• Closed as Permanent restriction.

Error description

• GENDRAFT / FRONT VIEW CANNOT BE CREATED
  AND ERROR MESSAGE OCCURS.
  .
  Operation:
  1. File/Open PART22.CATPart
  2. File/New
  Create new Drawing
  3. Select Front View
  4. Select Pad face in 3D space
  5. The following error detected and cannot create
  view.
  Drawing Error:
  No 3D element is available to project
  The model, product or part may be empty.
  In the case of a V4 model, make sure that there is
  a skin or an exact solid element to project.
  In the case of a part, make sure it is up-to-date.
  In the case of a 3D wireframe, go to Tools >
  Options > Drafting > View tab, and make sure that
  Project 3D wireframe is selected.
  In the case of a CATProcess document, select the
  product prior to plane selection.
  .
  

Local fix

Problem summary

• GENDRAFT / FRONT VIEW CANNOT BE CREATED AND ERROR MESSAGE OCCUR
  S
  GENDRAFT / FRONT VIEW CANNOT BE CREATED
  AND ERROR MESSAGE OCCURS.
  .
  Operation:
  1. File/Open PART22.CATPart
  2. File/New
  Create new Drawing
  3. Select Front View
  4. Select Pad face in 3D space
  5. The following error detected and cannot create
  view.
  Drawing Error:
  No 3D element is available to project
  The model, product or part may be empty.
  In the case of a V4 model, make sure that there is
  a skin or an exact solid element to project.
  In the case of a part, make sure it is up-to-date.
  In the case of a 3D wireframe, go to Tools >
  Options > Drafting > View tab, and make sure that
  Project 3D wireframe is selected.
  In the case of a CATProcess document, select the
  product prior to plane selection.
  .
  

Problem conclusion

• THIS PROBLEM IS PERMANENT RESTRICTION IN
  CATIA
  .
  Incident Diagnosis
  GENDRAFT / FRONT VIEW CANNOT BE CREATED
  AND ERROR MESSAGE OCCURS
  .
  Restriction Explanation
  .
  There is a data corruption on one internal
  container of the CATPart document. To clean the
  data, a change in the Part+Save is enough.
  e.g.
  1. activate the Chamfer.3
  2.De-activate again Chamfer.3
  3. Save the Part.
  .
  It is cleaned now. Now follow the scenario.It is OK.
  .
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels