HD52210: A RESULT OF GENERATED THREAD DOES NOT MATCH JIS STANDARD

APAR status

• Closed as suggestion for future release.

Error description

• According to JIS standard, Bolt part always
  displays with hiding nut part, but in CATIA, the
  thread representations of Bolt and Nut are
  projected with overlapped shape.
  Result:
  1- The lines which represent thread are overlaped
  2- Nut part representation hides Bolt part
  3- The thread lines of both Bolt and Nut are
  displayed
  4- The thread representation of Bolt and Nut are
  projected with overlapped shape.
  Expected Result:
  1- On Nut section view, the thread line is not
  displayed on the part which Bolt and Nut interfere
  2- Bolt part representation hides Nut part
  3- Only bolt thread is displayed
  4- The thread lines are not overlapped : only bolt is
  shown.
  .
  

Local fix

Problem summary

Problem conclusion

Temporary fix

Comments

• THIS APAR IS CONSIDERED AS A
  SUGGESTION FOR IMPROVEMENT WHICH
  CANNOT BE INCORPORATED IN VERSION
  V5R17PLEASE CONTACT YOUR SUPPORT
  DEPARTMENT IN ORDER TO OPEN A
  REQUIREMENT FORM.
  Incident Diagnosis
  A result of generated thread does not
  match JIS standard.
  Development Request Justification
  Some developments have to be done on
  the management of the 3D clash cases.
  Answer and By-Pass
  Use the Uncut option (see Generative
  Drafting documentation) to modify the blot
  attributes. In this case, hatching zone will
  be correctly displayed.
  .
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels