HD50788: FILLET IS DISPLAYED BY SOLID LINE AND DASHED LINE.

APAR status

• Closed as Permanent restriction.

Error description

• Scenario:
  1- File / Open the model
  2- AUXVIEW2 / USE / VIEW / NEW / Primary View
  3- Select Y axis then select X axis
  4- Indicate a location in the drawing window
  Result:
  Fillet is displayed by Solid line and dashed line.
  Expected Result:
  FILLET should be displayed only by Solid line
  
  
  
  
  .
  

Local fix

Problem summary

• Fillet is displayed by Solid line and dashed line.
  Scenario:
  1- File / Open the model
  2- AUXVIEW2 / USE / VIEW / NEW / Primary View
  3- Select Y axis then select X axis
  4- Indicate a location in the drawing window
  Result:
  Fillet is displayed by Solid line and dashed line.
  Expected Result:
  FILLET should be displayed only by Solid line
  
  
  
  
  .
  

Problem conclusion

• THIS PROBLEM IS PERMANENT RESTRICTION IN
  CATIA
  
  Incident Diagnosis
  Fillet is displayed by Solid line and dashed line.
  
  Restriction Explanation
  This V4 behavior cannot be improved.
  This problem occurs because of combition of very
  small fillet R=1mm and SAG=0.1
  
  By-Pass
  Use SAG=0.4 in this case.
  The apar HD31955 solves some cases but we
  cannot go further.
  
  .
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

  HD50787

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels