HD48591: REVISION ARE NOT DISPLAYED CORRECTLY WITH LIGHTWEIGHT MODE

APAR status

• Closed as unreproducible in next release.

Error description

• Revision are not displayed correctly with
  lightweight mode
  If lightweight mode is enabled in SolidWorks
  Integration, old revision are displayed to sub
  assemblies and parts in DMT although top
  assembly with the correct latest revision is
  displayed. If not using lightweight mode, all objects
  with correct revision are properly displayed in DMT.
  Prerequisite.
  SolidWorks
  Options.
  Enable "Automatically load components lightweight"
  options in SolidWorks
  options.
  - Performance-
  >Assembles
  -> Check On "Automatically load components
  lightweight"
  - Large Assembly
  Mode
  -> Check On "Automatically load components
  lightweight"
  .
  Scenario: Please
  see "lightweight.ppt".
  1. Create top assembly, two sub assemblies and
  two parts, save them  to
  SMARTEAM
  2. Check In all objects with "Keep Check Out" from
  top assembly in  SolidWorks
  Integration.
  3. Check In all objects with "Keep Local File" from
  top assembly in  SolidWorks
  Integration
  4. Check Out all assemblies and parts from profile
  card operation in SW and view
  them.
  5. Sub assemblies and parts with old revision are
  displayed in DMT.
  .
  

Local fix

Problem summary

• Revision are not displayed correctly with lightweight mode
  Revision are not displayed correctly with
  lightweight mode
  If lightweight mode is enabled in SolidWorks
  Integration, old revision are displayed to sub
  assemblies and parts in DMT although top
  assembly with the correct latest revision is
  displayed. If not using lightweight mode, all objects
  with correct revision are properly displayed in DMT.
  Prerequisite.
  SolidWorks
  Options.
  Enable "Automatically load components lightweight"
  options in SolidWorks
  options.
  - Performance-
  >Assembles
  -> Check On "Automatically load components
  lightweight"
  - Large Assembly
  Mode
  -> Check On "Automatically load components
  lightweight"
  .
  Scenario: Please
  see "lightweight.ppt".
  1. Create top assembly, two sub assemblies and
  two parts, save them  to
  SMARTEAM
  2. Check In all objects with "Keep Check Out" from
  top assembly in  SolidWorks
  Integration.
  3. Check In all objects with "Keep Local File" from
  top assembly in  SolidWorks
  Integration
  4. Check Out all assemblies and parts from profile
  card operation in SW and view
  them.
  5. Sub assemblies and parts with old revision are
  displayed in DMT.
  .
  

Problem conclusion

Temporary fix

Comments

• THE PROBLEM WAS SUBMITTED ON :
  SMARTEAM VERSION 5 RELEASE 14SP7.
  THIS PROBLEM IS NOT REPRODUCIBLE ON :
  SMARTEAM VERSION 5 RELEASE 17 GA level AND
  SW2006.
  .
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  SMARTEAM NT>XP

• Fixed component ID

  569199970

Applicable component levels

• R517 PSN

     UP