HD35159: PART DESIGN : DRAFT ANALYSIS DOES NOT WORK CORRECTLY

APAR status

• Closed as suggestion for future release.

Error description

• Problem:
  In the case of the slope of 3 degrees, Draft
  Analysis does not work correctly. By the "Draft
  Analysis" command, when the angle of a draft is
  three degrees or less, analysis is not performed
  correctly.
  .
  Scenario
  1. Start CATIAV5.
  2. Open Part1.CATPart.
  3. Check "Draft Angle".
  Draft.1=2.5deg
  Draft.2=2.0deg
  Draft.3=1.5deg
  Draft.4=1.0deg
  4. Select "Draft Analysis" icon.
  5. Select "Part Body" and set "Draft Analysis"
  panel.
  >>>Analysis is not performed correctly. This is
  trouble.
  .
  To click "inverse" is not a by-pass because it does
  not solve the problem at all.
  .
  Usually, it analyzes in many cases to the slope face
  of three degrees or less.
  .
  .
  

Local fix

Problem summary

Problem conclusion

Temporary fix

Comments

• THIS APAR IS CONSIDERED AS A SUGGESTION
  FOR IMPROVEMENT WHICH CANNOT BE
  INCORPORATED IN VERSION R15GA
  PLEASE CONTACT YOUR SUPPORT DEPARTMENT IN
  ORDER TO OPEN A REQUIREMENT FORM.
  .
  Diagnosis Analysis:
  Draft Analysis is not performed correctly.
  .
  Explanation :
  The correction cannot be provided on this level
  However, you have to click the "on the fly" button
  on in the Draft Analysis panel: you can get the
  measure message in the geometry. If the
  word "inverse" displays, you have to clik the
  inverse button on in the Draft Analysis panel
  because geomterically, the main vector is normally
  orthogonal to the surface towards to outside (and
  not inside).
  .
  .
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels