HD31355: PART DESIGN : IMPOSSIBLE TO CREATE A FILLET IN A SPECIFIC CASE.

APAR status

• Closed as suggestion for future release.

Error description

• PART DESIGN : Impossible to create a fillet in a
  specific case.
  It leads to following error messages : Multi ribbon
  operator : The operation cannot be initialized for
  one or more ribbon(s). Process each ribbon in a
  separate operation or Topological operator : The
  operation has a too large impact on the body.
  Some important portions of the body may
  disappear. Change the parameter value(s).
  .
  

Local fix

Problem summary

Problem conclusion

Temporary fix

Comments

• THIS APAR IS CONSIDERED AS A SUGGESTION
  FOR IMPROVEMENT WHICH CANNOT BE
  INCORPORATED IN VERSION V5R15 .
  PLEASE CONTACT YOUR SUPPORT DEPARTMENT IN
  ORDER TO OPEN A REQUIREMENT FORM.
  .
  Input geometry can be considered as complex
  because the shape is very specific (plane faces
  with high curvature and curving zones located on
  extremities).
  The problem is linked to some curves which are
  generated during the fillet creation.
  To solve properly this sensitive problem, the
  algorithm that generates the mapping between two
  curves must be improved.
  This algorithm should take into account geometry
  specificities (high curvature zones) and
  particularities, such as non curvilinear
  parameterization.
  With this improved algorithm, the twist detection of
  the fillet operator should be done safely.
  This development is planned to be done in V5R16
  level.
  .
  A by-pass consists in selecting another start edge.
  .
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels