HD05683: PARTDESIGN / IMPOSSIBLE RELIMITATION ERROR ON DRAFT WITH LIMITING PLANE

APAR status

• Closed as program error.

Error description

• SCENARIO :
  ---------
  1. Open delivered Part XXXXX.071.724.CATPart
  2. Edit Draft.1 and replace Plane.2 as Limiting Element with
  Plane.1
  ==> Error on Draft : "impossible relimitation. The local
  topology or geometry is too complex."
  .
  Plane.1 is located at an edge of EdgeFillet.1.
  .
  Remark :
  - If you move Plane.1 from 15mm to 15.02 mm it works.
  - If you move Plane.1 to 15.002 mm just ONE Face is drafted.
  

Local fix

Problem summary

• t
  PARTDESIGN / DRAFT WITH LIMITING PLANE IS ONLY PERFORMED ON
   ONE OF THE TWO SELECTED FACES
  

Problem conclusion

• THIS PROBLEM WILL BE FIXED ON CATIA VERSION 5 RELEASE 12 GA.
  COMMENT : NOTE THAT THIS PROBLEM WILL ALSO BE FIXED ON
  V5R11 SP04.
  .
  Incident diagnosis:
  PARTDESIGN / DRAFT WITH LIMITING PLANE IS ONLY PERFORMED ON
   ONE OF THE TWO SELECTED FACES
  .
  Answer: problem has been fixed: faces draft remain
  drafted after the modification of plane offset value.
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA VERSION 5

• Fixed component ID

  569101000

Applicable component levels

• R510 PSN SP51006

     UP03/07/02 N 1000

• R511 PSN SP51102

     UP03/06/06 N 1000