HD04679: DMUNAV : DMU IS BLOCKED DURING THE HANDLE OF CUMULATIVE SNAP COMMAND ON A SPECIFIC MODEL

APAR status

• Closed as program error.

Error description

• Hello DS,
  .
  1. Open a new CATProduct.
  2. Insert the two provided models by Insert + Existing
  Component method.
  3. Activate DMU Navigator workbench.
  4. Select the "Cumulative Snap" icon.
  5. Create a coincidence between the axis of the white part
  and an axis of one hole of the blue part.
  => When we try to select one hole of the blue part, DMU is
  blocked during some minutes. This behaviour appears at each
  time we pass the mouse on the blue part.
  Notice:
  1/ This Problem is linked to this model.
  2/ If the blue part is in design mode, DMU is not blocked
  anymore but we cannot select an inside face of any hole to
  create a coincidence
  .
  

Local fix

Problem summary

• INCIDENT DIAGNOSIS: DMUNav : DMU IS BLOCKED DURING THE HANDLE
  OF CUMULATIVE SNAP COMMAND ON A SPECIFIC MODEL
  

Problem conclusion

• THIS PROBLEM WILL BE FIXED ON
  CATIA VERSION 5 RELEASE 11 GA level.
  NOTE THAT THIS PROBLEM WILL ALSO BE FIXED ON V5R10SP05.
  
  
  TECHNICAL EXPLANATION FOR THE CORRECTION:
  This problem has been corrected. The DMU is not blocked anymore
  while you try to select one hole of your specific model
  .
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  ENOVIA DMU SUN

• Fixed component ID

  569104800

Applicable component levels

• R509 PSN

     UP

• R510 PSN SP51005

     UP03/04/25 N 1000

• R511 PSN

     UP