HD03721: PLANAR SURFACE RESULTING OF EXTRUSION OF LINE BUILT BY "POINT-DIRECTION" CANNOT BE USED TO SKECTCHER.

APAR status

• Closed as program error.

Error description

• 1. Create new CATPart.
  2. Go to the GSD WB.
  3. Click Point icon.
  4. Create a point to x,y,z =0,0,0.
  5. Click line icon.
     Setup as follows:
        Line type :  Point-Direction
        Point     :  Point.1
        Direction :  yz plane
        Support   :  xy plane
        Start     :  -50 mm
        End       :  +50 mm
  6. Click OK. (A straight line is created. )
  7. Click Extrude icon.
      Setup as follows:
        Prifile   :  Line.1
        Direction :  zx plane
        Limit 1   : 50 mm
        Limit 2   : 0mm
  8. Click OK. (A surface is created. )
  9. Click Sketcher icon.
  10.Select surface which was created by step8.
   ==> SURFACE ISN'T USEABLE TO SKETCHER
  BYPASS: If the line is created by "NORMAL ANGLE", it is OK.
  

Local fix

Problem summary

• PLANAR SURFACE RESULTING OF EXTRUSION OF LINE BUILT BY
  POINT-DIRECTION CANNOT BE USED FOR SKETCHER.
  

Problem conclusion

• THIS PROBLEM WILL BE FIXED ON
    CATIA VERSION 5 RELEASE 11 GA level.
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Modules/Macros

•    FILE
  

Fix information

• Fixed component name

  CATIA V5/NT/200

• Fixed component ID

  569151000

Applicable component levels

• R509 PSN

     UP

• R510 PSN

     UP