HC93705: SHAPEDSG WORK ON SUPPORT : SOME FEATURES CAN BE CREATED, SOME OTHERS CANNOT.

APAR status

• Closed as user error.

Error description

• Scenario:
  1. Open provided CATPart
  >>Workbench is SHAPDSGN
  2. Select "Work on Support" icon.
  >>Work on Support window is displayed.
  3. Select ￭Pad.1 Face then Click "OK".
  4.Try to create Polyline, Point, or Line (angle normal to
  curve) remote from the face.
  >>it's OK
  5.Try to create Spline, Circle, or Line (Point-Point) remote
  from the face
  
  Problem:
  Update Error is displayed.
  "Topological operators: an input wire does not lie on the
  shell support. Project it on the support,and use this
  projection."
  

Local fix

Problem summary

Problem conclusion

Temporary fix

Comments

•  INCIDENT DIAGNOSIS:
  WORK ON SUPPORT WITH SUB ELEMENTS:
  SOME FEATURES CAN BE CREATED, SOME OTHERS CANNOT.
  
  
   CORRECT APPLICATION:
  the feature taken as example do not use the support for the
  same purpose, this explains why the behavior is different :
  - for polyline : the support is not an input spec of the fea
  ture, it is only used to increase productivity by allowing to
  create points on the fly on the support when needed. The result
  is not always on the support
  - for line, circle, spline : the support is an input spec of
  the feature (displayed in the panel), and the resulting
  geometry is built on this support, so if the result is not on it
  there is an error.
  The only exception is for point on plane where we allow to
  create a point outside a face. This is for productivity.
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels