HC93350: PARTDESIGN / EDGE FILLET / IMPOSSIBLE TO CREATE FILLET : ' RIBBON HAS STOPPED ON SLIGHTLY SHARP EDGE ' UPDATE ERROR

APAR status

• Closed as suggestion for future release.

Error description

• Fillet impossible to create, because of an existing sharp
  edge that stops the ribbon propagation.
  --> Update error is displayed :
  ' Ribbon has stopped on slighly sharp edge'
  

Local fix

Problem summary

Problem conclusion

Temporary fix

Comments

• THIS APAR IS CONSIDERED AS A SUGGESTION FOR IMPROVEMENT FOR
  CATIA.
  PLEASE CONTACT YOUR SUPPORT DEPARTMENT IN ORDER TO OPEN A
  REQUIREMENT FORM.
   .
   INCIDENT DIAGNOSIS:
    ===> PARTDESIGN / EDGE FILLET / IMPOSSIBLE TO CREATE FILLET :
   RIBBON HAS
    STOPPED ON SLIGHTLY SHARP EDGE ' UPDATE ERROR
    .
   JUSTIFICATION FOR DEVLOPMENT REQUEST:
  The fillet ribbon has stopped on a slightly sharp edge. (but
   the tangent
  discontinuity is greater than 0.5 degree).
  We have implemented an diagnosis help in order to identify
  this situation.
   .
  A development is planned for the future releases in order to
  ignore these sharp edges and to go on propagate over them.
   .
   ANSWER AND POSSIBLE BY-PASS:
  Modify the support geometry.
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels