HC92235: PARTDESIGN / SKETCH / INCOMPREHENSIBLE AUTOCROSSING PROFILE WARNING IN SKETCH ANALYSIS LEADS TO PAD CREATION FAILURE

APAR status

• Closed as user error.

Error description

• Warning appears in Sketch Analysis and cannot create Pad.
  or find the element which is given warning.
  .
  SCENARIO : (modele dependant)
  ----------
  1.Open the .CATDrawing.
  2.Copy the figure of 'S' in sheet.1.
  3.Create a new Part.
  4.Paste the figure of 'S' onto XY plane.
  5.Tools - Sketch Analysis.
    The following warning appears in Sketch Analysis dialog.
    ***************************************
      General Status
        Warning: Non manifold topology
      Detailed Information
        Warning: Autocrossing profile.
     **************************************
  6.Close Sketch Analysis dialog.
  7.Exit Sketcher.
  8.Create Pad with this sketch.
  -->  The following error appears and cannot create Pad with
  this sketch.
    ***************************************
      Feature Definition Error
      The selected sketch isn't valid for
      the feature you want to create.
    ***************************************
  

Local fix

Problem summary

Problem conclusion

Temporary fix

Comments

•  INCIDENT DIAGNOSIS:
  Geometry of a curve of the CATDrawing has been found invalid:
  PSpline located at (0.0;5.39223) coordinates is strongly
  curved and autointersection of the S wire has been detected.
    .
   CORRECT APPLICATION:
  The origin of the file has been suspected.
  Conversion problem from HDI may be the cause of the curve
  invalidity ; the CATDrawing comes from HDD drawing.
   Investigation about conversion is strongly recommended.
   .
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels