HC85409: MOLDTOOL - CANNOT FIND MOLD PARTS CREATED BY NEW MOLD WHEN CACHE IS ENABLED BUT IT IS OK WHEN CACHE IS DISABLED

APAR status

• Closed as suggestion for future release.

Error description

• MOLDTOOL - CANNOT FIND MOLD PARTS CREATED BY NEW MOLD WHEN CACHE
  IS ENABLED BUT IT IS OK WHEN CACHE IS DISABLED
  
  SCENARIO:
  1. Check that cache management are activated.
  2. Enter Mold design workbench.
  3. Select the "New Mold" icon. and press OK.
  4. You are now told that CATIA can not find the different parts
     for the mold base (The mandatory Cavity plate could not be
  found)
  5. Switch of cache management and try the same.
  6. Now it is possible to create the mold base without problems.
  7. CATIA should place parts when they are selected in the
     catalogs even though cache management are activated.
  8. This is critical because mold assemblies gets very big and
     if you are not able to work with cache management you get
     very poor performance.
  

Local fix

Problem summary

Problem conclusion

Temporary fix

Comments

• THIS APAR IS CONSIDERED AS A SUGGESTION FOR IMPROVEMENT FOR
  CATIA.
  .
   INCIDENT DIAGNOSIS:
  Cache system disabled in MTD
   .
   JUSTIFICATION FOR DEVLOPMENT REQUEST:
  This limitation is mentionned in the Program Directory.
  Planned to be treated in V5R9.
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels