HC83918: SHMAERO- SOLID REPRESENTATION OF FLANGE SHOWS JAGGED EDGE ON WALL/FLANGE TRANSITION

APAR status

• Closed as suggestion for future release.

Error description

• SHMAERO- SOLID REPRESENTATION OF FLANGE SHOWS JAGGED EDGE ON
  WALL/FLANGE TRANSITION
  
  Scenario
  1. Open test model
  2. Select FK SHM_AERO
  3. Create a part that is 0.04 inches thick with a Min. Bend
  Radius
       of 0.09 in.
  4. Select OK
  5. Select *PLN1 for the Support Geometry
       (Material Direction should be in positive Z)
  6. Select the curve and 3 lines in counter-clockwise direction
  7. Select YES: closed contour defined
  8. Select OK in Create Web window
  9. Select Workmode Options from Actions on Part window
  10. Set "Update part as" to Solid
  11. Select OK
  12. Select "Define a Flange" icon from Select or Create a
  Feature window
  13. Select the curve
  14. Key in 60 for the angle and hit enter
  15. Set the "Edge of Part" to "From OML" and Length to 1.0 in.
  16. Select "Flange sides..." button in Create Flange window
  17. For Side 1:
        set Limit to "on folded part"
        select *PLN2
  18. For Side 2:
        set Limit to "on folded part"
        select *PLN3
  19. Select OK in Side Limit window
  20. Select OK in Create Flange window
  21. Zoom in on near corner of bend to see the jagged edge.
  

Local fix

Problem summary

Problem conclusion

Temporary fix

Comments

• THIS APAR IS CONSIDERED AS A SUGGESTION FOR IMPROVEMENT FOR
  CATIA.
  
  This issue will be solved on CATIA 424 R2 level.
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

  HC83916

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels