HC82605: TOO LARGE DISPLACEMENT IS RETURNED BY ROUTINE GQQSTP THROUGH GII ERGO (KINEMUSE) USING 422R1 MR8 (REGRESSION AGAINST 422R1 MR6)

APAR status

• Closed as Permanent restriction.

Error description

• TOO LARGE DISPLACEMENT IS RETURNED BY ROUTINE GQQSTP THROUGH GII
  ERGO USING 422R1 MR8 (REGRESSION AGAINST 422R1 MR6)
  
  Scenario:
  =========
  1. Read model (ERGO TEST MODEL.)
  2. ERGO + FR MANKN + INPUT : ckick INPUT item to display the
     front manikin accomodation panel
  3. Select or type the entries for computation
  .3.1 Acceleration pedal curve : *CRV262.
  .    This is the white curve that runs from under the
  .    sole (light blue) of the shoe to the front wheel
  .    opening curve.
  .3.2 Floor Pan Curve : *CRV258.
  .    This is the white curve that runs through the point
  .    at the heel and extend parallel to the floor of the
  .    car and ends below the knee of the front mannequin.
  .3.3 Preliminary Heel point : *PT43.
  .    White point at the heel of the shoe of the front
  .    mannequin.
  .3.4 H-Point travel line : *LN4.
  .    This is the yellow line that extends from the hip of
   .    the front mannequin and extend forward toward.
  4. click the ACCEPT button
  5. click the CLOSE button
  6. click SP 2D button and enter Y=-329.5 as 2D plane
  7. ERGO + FR MANKN + EXECUTE, Yes:execute
  => TOO LARGE DISPLACEMENTS
  Error occured while computing !!!
  
  ***************************************************
  *         ERROR IN CATGEO/CATMSP SOFTWARE         *
  *         ERROR WHEN USING  SUBROUTINE : GQQSTP   *
  *         CURRENT MODEL NUMBER :    1             *
  *         ERROR CODE :  9034      SEVERITY  4     *
  * ------------------------------------------------*
  *   TOO LARGE DISPLACEMENTS                       *
  **************************************************
  
  ils.  Problem began when CATIA MR8 was installed.    Problem on
  both the IBM and the SGI workstation. No changes madeto this GII
   ERGO. GII ERGO works correctly on MR6.  The GII     fails after
   several iterations from CATGEO GQQSTP.  The CATGEO  routine is
  from the Kinematic's package.
  

Local fix

Problem summary

•  no
  

Problem conclusion

• THIS PROBLEM IS PERMANENT RESTRICTION IN CATIA.
  PRS closing is motivated by the fact that it is very difficult
  to perform any correction at this stage because there is a high
  risk of creating many regressions and instability in software.
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

  HC82606 HC82607 HC82609

Modules/Macros

•    NO
  

Fix information

Applicable component levels