HC82287: MFGPROG / 3 AXIS ISOFAC : IMPOSSIBLE TO SELECT FACES OF THE SOLID AS PART GEOMETRY WITHOUT EXTRACTING THEM FROM THE SOLID.

APAR status

• Closed as Permanent restriction.

Error description

• ABSTRACT:
  MFGPROG / 3 AXIS ISOFAC : IMPOSSIBLE TO SELECT FACES OF THE
  SOLID AS PART GEOMETRY WITHOUT EXTRACTING THEM FROM THE SOLID.
  
  DESCRIPTION:
  The example model has a very simple solid with a filleted hole
  in it. The solid cannot be used to define the 3 axis iso face
  Machining operation. The operation in the example model uses
  extracted faces to define the NC motion.
  
  
  ABSTRACT:
  MFGPROG / 3 AXIS ISOFAC : IMPOSSIBLE TO SELECT FACES OF THE
  SOLID AS PART GEOMETRY WITHOUT EXTRACTING THEM FROM THE SOLID.
  
  DESCRIPTION:
  The example model has a very simple solid with a filleted hole
  in it. The solid cannot be used to define the 3 axis iso face
  Machining operation. The operation in the example model uses
  extracted faces to define the NC motion.
  

Local fix

Problem summary

•  INCIDENT DIAGNOSIS:
  MFGPROG / 3 AXIS ISOFAC : IMPOSSIBLE TO SELECT FACES OF THE
  SOLID AS PART GEOMETRY WITHOUT EXTRACTING THEM FROM THE SOLID.
  

Problem conclusion

• THIS PROBLEM IS PERMANENT RESTRICTION IN CATIA
  
   TECHNICAL EXPLANATION FOR THE RESTRICTION:
  Limitation in the solid software which allows to have an
  evaluation of an edge in two pieces. It happens when you have
  two cylindrical adjacent RSURs composing a hole for example.
  
   BY-PASS:
  Extract the faces from RSURs to use them as part elements
  for the 3 axix ISOFAC operation.
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

  HC82285

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels