HC73071: SKETCHER CONSTRUCTION/STANDARD ELEMENT DEFAULT MODE IS MISSING.

APAR status

• Closed as suggestion for future release.

Error description

• Scenario:
  1. Start CATIA V5
  2. Start new part
  3. Start sketcher on any plane.
  4. Click free profile icon (a rectangle or more complex shape)
  5. Using selection trap select the whole sketch
     (lines and points)
  6. Select Construction/Standard Element icon
  7. Select Construction/Standard Element icon again
     Lines who were in standard mode are again in standard mode
     Points who were in Construction mode are now in
     standard mode.
  ==> It is no more possible to restore the original state :
      Lines in standard mode and Points in Construction mode.
  

Local fix

Problem summary

Problem conclusion

Temporary fix

Comments

• THIS APAR IS CONSIDERED AS A SUGGESTION FOR IMPROVEMENT FOR
  CATIA.
  PLEASE CONTACT YOUR SUPPORT DEPARTMENT IN ORDER TO OPEN A
  REQUIREMENT FORM.
  
  It is not possible to filter elements selected by a multisel
  for Construction/Standard Element switch
  
  Development plans to add a panel showing selected points
  and asking to keep these points selected or not.
  
  To avoid points selection belonging to a sketch
  three ways are already available:
   * Do an autoseach (ignoring limites points)
   * Select the geometry and then unselect unwanted points
   * use Tools/Sketch Analysis command to check Sketch problem
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels