HC44171: ERROR GENERATING ISOMETRIC IF THERE IS A PIPE WITH MORE THAN 2 BRANCHES, REFER TO EXTENDED DESC FOR MODEL.

APAR status

• Closed as Permanent restriction.

Error description

• ABSTRACT:  Error generating isometric if there is a pipe with
  more than 2 branches
  Function: PIPE_DES/Fabrication/Preview or ISO_EXTR/Execute
  The iso extraction does not generate the drawing if there is
  a pipe with more than two branches.
  The error message is issued: Error in analysis process
  
  Refer to model in /u/users/sb03524/PMRS/pmr09785
  Run an ISO on this, problem is recreated.
  

Local fix

Problem summary

• This is a limitation of ISO.  You can only have two branch
  connectors on the same pipe at the same centerline location
  Now, you can have more branches at other locations,
  and ISO works fine.  But this is an ISO restriction.
  

Problem conclusion

• THIS PROBLEM IS PERMANENT RESTRICTION IN CATIA
  
  This is a limitation of ISO.  You can only have two branch
  onnectors on the same pipe at the same centerline location.
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

  HC44169

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels