Product Documentation
Abstract
The following illustration shows how to remove the top cover and bezel from the server. NOTE: The illustrations in this document might differ slightly from the hardware. 1. Top cover 2. Right release latch 3. Bezel 4. Left release latch
Content
The following illustration shows how to remove the top cover and bezel from the server.
NOTE: The illustrations in this document might differ slightly from the hardware.
1. Top cover
2. Right release latch
3. Bezel
4. Left release latch
5. Cover release latch
| Removing the server top cover |
|---|
- Lift the plastic cover-release latch near the edge of the top cover. Slide the top cover slightly toward the rear of the server; the cover will stop after about 25 mm (1 inch). Lift the cover off the server and set the cover aside.
WARNING: For proper cooling and airflow, replace the top cover before turning on the server. Operating the server for extended periods of time (over 30 minutes) with the top cover removed might damage server components.
| Removing the bezel |
|---|
- Release the two tabs at the top edge of the bezel and pull the top of the bezel slightly away from the server.
- Pull the bezel up to release the two tabs at the bottom edge of the bezel. Store the bezel in a safe place.
Document Location
Worldwide
[{"Type":"HW","Business Unit":{"code":"BU016","label":"Multiple Vendor Support"},"Product":{"code":"HW18V","label":"Older System x->xSeries 350"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Line of Business":{"code":"","label":""}},{"Type":"HW","Business Unit":{"code":"BU016","label":"Multiple Vendor Support"},"Product":{"code":"HWN12","label":"Older System x->Netfinity 6000R"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Line of Business":{"code":"","label":""}}]
Was this topic helpful?
Document Information
Modified date:
24 January 2019
UID
ibm1MIGR-45551