Resume Line Recovery (RSMLINRCY)
| Where allowed to run: All environments (*ALL) Threadsafe: No |
Parameters Examples Error messages |
The Resume Line Recovery (RSMLINRCY) command resumes error recovery procedures for a specific line. Error recovery procedures are ended by the End Line Recovery (ENDLINRCY) command or by responding to a failure-related inquiry message with a cancel option.
The Resume Line Recovery (RSMLINRCY) command allows you to resume automatic error recovery procedures after they stop, and to reactivate a line (and jobs using that line) after it is canceled (if the C response was entered to the inquiry message associated with a line failure). When the line is canceled with the C response, all jobs are ended; once the line is repaired and the RSMLINRCY command is entered, jobs are allowed to start using the line again.
Restriction: To use this command, the user must have object operational authority for the line.
| Top |
Line (LINE)
Specifies the name of the communications line whose recovery is started again.
This is a required parameter.
| Top |
Examples
RSMLINRCY LINE(NYC2)
This command resumes error recovery procedures for the line NYC2 to resume.
| Top |
Error messages
*ESCAPE Messages
- CPF2704
- Line description &1 not found.
- CPF5917
- Not authorized to line description &1.
- CPF5932
- Cannot access line &1.
- CPF5933
- Line &1 not varied on.
- CPF5934
- Recovery not resumed for line &1.
- CPF5935
- Error occurred during command processing.
| Top |