Remove Media Volumes from BRM (RMVMEDBRM)
Where allowed to run: All environments (*ALL) Threadsafe: No |
Parameters Examples Error messages |
The Remove Media Volumes from BRM (RMVMEDBRM) command removes a media volume from the BRMS media inventory. A volume is removed because of age, error rate, shipment to another location, and so on.
Note: Media can only be removed if it was previously added using the ADDMEDBRM command. All information about the volume including content and statistics, is deleted when the volume is removed. Also the total number of volumes in BRMS is decremented.
To use this command, you must have the Backup Recovery and Media Services for IBM i licensed program installed.
Top |
Parameters
Keyword | Description | Choices | Notes |
---|---|---|---|
VOL | Volume identifier | Character value | Required, Positional 1 |
Top |
Volume identifier (VOL)
Specifies the volume identifier of the volume being removed from the BRMS media inventory.
This is a required parameter.
- volume-identifier
- Specify the identifier of the volume being removed from the media inventory.
Top |
Examples
Example 1: Removing a Volume from BRMS
RMVMEDBRM VOL(C00005)
This command removes volume C00005 from the BRMS media inventory.
Top |
Error messages
*ESCAPE Messages
- BRM1147
- Volume &1 not found.
- BRM1917
- Feature not installed.
- BRM1921
- Feature not licensed.
- BRM4040
- Access denied for user &1.
- BRM4041
- Access denied for user &1.
- BRM40A2
- BRMS product initialization required.
- CPF9800
- All CPF98xx messages could be signaled. xx is from 01 to FF.
Top |