Remove Access Code (RMVACC)
Where allowed to run: All environments (*ALL) Threadsafe: No |
Parameters Examples Error messages |
The Remove Access Code (RMVACC) command allows you to remove from the system an access code previously defined by the Add Access Code (ADDACC) command.
NOTES:
- This command can take a long time to run because it must update each object in the document library that has been assigned the access code being removed.
- This command removes the access code from all filed documents, from all users authorized to the access code, and from the system.
Restrictions:
To use this command, you must have all object (*ALLOBJ) special authority.
Top |
Parameters
Keyword | Description | Choices | Notes |
---|---|---|---|
ACC | Document access code | Values (up to 300 repetitions): 1-2047 | Required, Positional 1 |
Top |
Document access code (ACC)
Specifies the access code or access codes being removed from the system. If the access code specified is not defined on the system, a diagnostic message is sent, and any additional access codes specified are processed.
- 1-2047
- Specify an access code to be removed from the system.
This is a required parameter.
Top |
Top |
Error messages
*ESCAPE Messages
- CPF90A5
- Access codes could not be removed.
- CPF9009
- System requires file &1 in &2 be journaled.
- CPF9011
- &1 access codes removed, &2 not removed.
- CPF9024
- System cannot get correct record to finish operation.
- CPF9845
- Error occurred while opening file &1.
- CPF9846
- Error while processing file &1 in library &2.
- CPF9847
- Error occurred while closing file &1 in library &2.
Top |