End Line Recovery (ENDLINRCY)

Where allowed to run: All environments (*ALL)
Threadsafe: No

The End Line Recovery (ENDLINRCY) command ends automatic error recovery procedures for a specific line. If any type of failure occurs after this command is run, an inquiry message is sent to the system operator.

Use the Resume Line Recovery (RSMLINRCY) command to reestablish error recovery procedures for the line.

Top

Parameters

Keyword	Description	Choices	Notes
LINE	Line	Name	Required, Positional 1

Top

Line (LINE)

Specifies the name of the communications line whose recovery is to be stopped.

This is a required parameter.

Top

Examples

ENDLINRCY   LINE(NYC2)

This command ends error recovery procedures for the line named NYC2.

Top

Error messages

*ESCAPE Messages

CPF2704: Line description &1 not found.
CPF5917: Not authorized to line description &1.
CPF5932: Cannot access line &1.
CPF5933: Line &1 not varied on.
CPF5935: Error occurred during command processing.

Top