End Controller Recovery (ENDCTLRCY)

Where allowed to run: All environments (*ALL)
Threadsafe: No

The End Controller Recovery (ENDCTLRCY) command ends automatic error recovery procedures for a specific controller. If any type of failure occurs after this command is run, an inquiry message is sent to the system operator.

Use the Resume Controller Recovery (RSMCTLRCY) command to reestablish error recovery procedures for the controller.

Top

Parameters

Keyword	Description	Choices	Notes
CTL	Controller	Name	Required, Positional 1

Top

Controller (CTL)

Specifies the controller whose recovery is to be ended.

This is a required parameter.

Top

Examples

ENDCTLRCY   CTL(TROLL3)

This command ends error recovery procedures for the controller TROLL3.

Top

Error messages

*ESCAPE Messages

CPF2703: Controller description &1 not found.
CPF5924: Controller &1 does not allow automatic error recovery.
CPF5928: Controller &1 not varied on.
CPF5929: Controller &1 assigned to another job.
CPF5935: Error occurred during command processing.
CPF5936: Not authorized to controller &1.

Top