Delete Line Description (DLTLIND)

The Delete Line Description (DLTLIND) command deletes the specified line description. The line description must be varied offline before this command is issued to delete it.

Note: If you are deleting a line attached to a frame relay network interface, the network interface (NWI) must also be varied offline.

Parameters

Line description (LIND)

Specifies the names of one or more line description to delete. A specific line description or a generic line description can be specified.

name

Specify the name of the line description to delete.

generic-name

Specify the generic name of the line descriptions to delete.

Note: A generic name is specified as a character string that contains one or more characters followed by an asterisk (*). If a generic name is specified, then all objects that have names with the same prefix as the generic object name are selected.

Examples

DLTLIND   LIND(LINE01)

This command deletes the line description of the line named LINE01 from the system.

If the line description being deleted has any controller descriptions associated with it, they are detached and a message containing those controller names is sent to the system operator. The detached controller descriptions are associated with a new line description if their names are specified in the command that creates the line description.

Error messages

*ESCAPE Messages

CPF2105

Object &1 in &2 type *&3 not found.

CPF2114

Cannot allocate object &1 in &2 type *&3.

CPF2117

&4 objects type *&3 deleted. &5 objects not deleted.

CPF2189

Not authorized to object &1 in &2 type *&3.

CPF26AB

Line &1 cannot be deleted while varied on.

CPF2625

Not able to allocate object &1.

CPF2627

Controller description previously deleted.

CPF2634

Not authorized to object &1.

CPF2668

Object description not deleted.