Installing secondary languages for non-IBM licensed programs

To install a secondary language for non-IBM licensed programs, follow these steps.

You might be instructed to use the IBM® i Restore Licensed Program (RSTLICPGM) command to install secondary languages for non-IBM licensed programs. All IBM-supplied licensed programs, including Programming Request for Price Quotations (PRPQs), licensed program offerings (LPOs), and single-set licensed programs, should have had secondary languages installed already by using the LICPGM menu option 21.

Note: If you do not have non-IBM licensed programs, you can skip this task. However, you must complete the installation process. Go to Checklist: Completing the IBM i installation and complete the instructions.

You might have received special installation instructions with independently shipped licensed programs (those that are not on the same media as the software release). If you did, you should use those instructions.
Load the media volume containing the secondary language that you want to install.
In the following steps, OPT01 is used for the installation device. If you are using a different naming convention, use the name you have assigned to the installation device.
To install a secondary language for a licensed program, type this command and press Enter:
```
RSTLICPGM LICPGM(xxxxxxx) DEV(OPT01)
  OPTION(*BASE) RSTOBJ(*LNG) LNG(29xx)
```
where xxxxxxx is the product identifier for the licensed program and 29xx is the national language version feature code.
To install secondary language for an optional part of a licensed program, type this command and press Enter:
```
RSTLICPGM LICPGM(xxxxxxx) DEV(OPT01)
  OPTION(n) RSTOBJ(*LNG) LNG(29xx)
```
where xxxxxxx is the product identifier for the licensed program, n is the option number, and 29xx is the national language version feature code.
Repeat steps 3 and 4 until you have installed all of the secondary languages for the licensed programs and optional parts that were independently installed.

You have completed this task.

You must complete the installation process before you put your system into operation. Go to Checklist: Completing the IBM i installation and complete the instructions.