Simple example: Batch FTP

This simple example shows a batch file transfer that involves the successful transfer of one file from a remote system.

The components are as follows:

The CL program

  ************************************************************ 
     ITSOLIB1/QCLSRC BATCHFTP: 
     ---------------------- 
         PGM 
         OVRDBF   FILE(INPUT) TOFILE(ITSOLIB1/QCLSRC) MBR(FTPCMDS) 
         OVRDBF   FILE(OUTPUT) TOFILE(ITSOLIB1/QCLSRC) MBR(OUT) 
         FTP      RMTSYS(SYSxxx) 
         ENDPGM 
  ************************************************************ 
Note: To make this sample work when written with ILECL, you must add OVRSCOPE(*CALLLVL) to the OVRDBF commands.

The BATCHFTP program overrides the INPUT parameter to the source physical file ITSOLIB1/QCLSRC MBR(FTPCMDS). The output is sent to MBR(OUT).

The input commands file

     ************************************************************ 
     ITSOLIB1/QCLSRC FTPCMDS: 
     --------------------- 
     ITSO ITSO 
     CD ITSOLIB1 
     SYSCMD CHGCURLIB ITSOLIB2 
     GET QCLSRC.BATCHFTP QCLSRC.BATCHFTP (REPLACE 
     QUIT 
     ************************************************************ 

The FTP subcommands required are shown in the FTPCMDS file.

The output messages file

     ************************************************************ 
     FTP Output Redirected to a File 
     FTP Input from Overridden File 
     Connecting to host name SYSxxx 
     at address x.xxx.xx.xxx using port 21. 
     220-QTCP at SYSxxx.sysnam123.ibm.com. 
     220 Connection will close if idle more than 5 minutes. 
     Enter login ID (itso): 
     > ITSO ITSO 
     331 Enter password. 
     230 ITSO logged on. 
      i5/OS is the remote operating system.  The TCP/IP version is "V3R1M0". 
     250  Now using naming format "0". 
     257 "QGPL" is current library. 
     Enter an FTP subcommand. 
     > CD ITSOLIB1 
     Enter an FTP subcommand. 
     250 Current library changed to ITSOLIB1. 
     > SYSCMD CHGCURLIB ITSOLIB2 
     Enter an FTP subcommand. 
     > GET QCLSRC.BATCHFTP QCLSRC.BATCHFTP (REPLACE 
     200 PORT subcommand request successful. 
     150 Retrieving member BATCHFTP in file QCLSRC in library ITSOLIB1. 
     250 File transfer completed successfully. 
     147 bytes transferred in 0.487 seconds. Transfer rate 0.302 KB/sec. 
     Enter an FTP subcommand. 
     > QUIT 
     221 QUIT subcommand received. 
     ************************************************************ 

The output file is shown. It is a straightforward matter to write a program to process this file and display an error message on QSYSOPR if there are any error messages. FTP error messages have numbers that start with a 4 or 5.