Changing TFTP attributes

To change the Trivial File Transfer Protocol (TFTP) server attributes, use the Change TCP/IP TFTP Attributes (CHGTFTPA) command.

The following are two different ways to get to this command prompt:

Specify the CHGTFTPA command.
Select option 3 on the Configure TCP/IP Applications (CFGTCPAPP) display.

Note: You must have *IOSYSCFG special authority to make changes to the TFTP attributes with the CHGTFTPA command.

Figure 1. Change TFTP Attributes (CHGTFTPA) – Display 1

                        Change TFTP Attributes (CHGTFTPA)
 
 Type choices, press Enter.
 
 Autostart server . . . . . . . .   *NO           *YES, *NO, *SAME
 Enable subnet broadcast  . . . .   *YES          *YES, *NO, *SAME
 Number of server jobs:
   Minimum  . . . . . . . . . . .   2             1-20, *SAME, *DFT
   Maximum  . . . . . . . . . . .   6             1-250, *SAME, *DFT
 Server inactivity timer  . . . .   30            1-1440, *SAME, *DFT
 ASCII single byte CCSID:
   Coded character set identifier   00819         1-65532, *SAME, *DFT
 Maximum block size . . . . . . .   1024          512-65464, *SAME, *DFT
 Connection response timeout  . .   60            1-600, *SAME, *DFT
 Allow file writes  . . . . . . .   *NONE         *DFT, *NONE, *CREATE...
 Alternate source directory . . .   '*NONE'
 
 
 
 
 
                                                                         More...
 F3=Exit   F4=Prompt   F5=Refresh   F12=Cancel   F13=How to use this display
 F24=More keys

Figure 2. Change TFTP Attributes (CHGTFTPA) – Display 2

                         Change TFTP Attributes (CHGTFTPA)
 
  Type choices, press Enter.
 
  Alternate target directory . . .   '*NONE'