Configuration parameters for AFM-based DR

The following table lists the AFM-based DR configuration parameters with their default values and the commands to set and edit the parameters:

Table 1. Configuration parameters at primary and their default values

AFM configuration parameter	Unit	Description	Mode on AFM-DR
afmAsyncDelay	Seconds	Indicates the time at which the requests start flushing to the home cluster. For write-intensive applications that write to the same set of files, this delay is helpful because it replaces multiple writes to the home cluster with a single write containing the latest data. However, setting a very high value weakens the consistency of the data on the remote cluster.	primary
afmDisconnectTimeout	Seconds	Defines the interval until which the MDS waits after it detects that the home cluster is inaccessible before declaring the outage by moving the cache cluster state to Disconnected.	primary
mountRetryInterval	Seconds	Specifies the interval after which the MDS retries an operation at home, in cases where the home is in an unhealthy state. Needs the GW node recycle or -i option for immediate effect. It is tunable per gateway. The updated value is visible only as long as the gateway is active and is applicable for all filesets owned by that gateway.	primary
afmRPO	Minutes	Specifies the interval for generating RPO snapshots.	primary

Table 2. Configuration parameters at primary and their default values - Valid values

AFM configuration parameter	Valid values	Default value	Tunable at the cluster level	Tunable at the fileset level
afmAsyncDelay	1 - 2147483647	15	Yes	Yes
afmDisconnectTimeout	0 - 2147483647, disable	60	Yes	No
mountRetryInterval		300	No	No
afmRPO	720 - 2147483647	disabled	No	Yes