Complete this task to use DHCP server settings to assign
an IPv4 address.
About this task
To specify that the DHCP server assign an IPv4 address,
use the following method.
Procedure
- From the library's Activity touchscreen, press MENU
—> Settings —> Network —> Ethernet IPv4—> ENTER.
The
Ethernet screen displays Ethernet settings for Frame 1 If
the library contains more than one frame, press UP or DOWN to view
the settings for the next or previous frame.
If the frame contains
more than one Ethernet port, press UP or DOWN to view the settings
for each port.Ethernet IPv4 Panel 0175
Current Settings Frame 1:
MAC Address: 18:36:F3:98:4F:9A
IP Address (IPv4): 19.117.63.126
Subnet Mask (IPv4): 255.255.253.0
Gateway (IPv4): 19.117.63.253
Ethernet Mode: Static IP
Press ENTER to Change Settings
[BACK] [ UP ] [DOWN] [ENTER]
- To change the Ethernet setting, press ENTER.
The
Ethernet Settings menu displays.
Ethernet Settings IPv4 Panel 0176
Disable Ethernet
Enable with DHCP
Enable with Static IP
[BACK] [ UP ] [DOWN] [ENTER]
- Press UP or DOWN to highlight Enable with DHCP and press
ENTER.
- The library displays the message If you select ENTER, the Ethernet
Settings will be obtained through the DHCP server. Press ENTER to
continue. Press ENTER to obtain the settings.
- The library displays the message Enabling DHCP settings. This
may take up to four minutes. followed by DHCP Enabled.
- Press ENTER. The Ethernet menu redisplays with the new setting.
- Press BACK until you return to the Activity screen.