Replacing a Storwize V7000 Gen2 CMOS battery

The complementary metal-oxide semiconductor (CMOS) battery is a coin-shaped power cell that is mounted inside a node canister. It is used to keep the system time when there is no power to the node canister. The lithium battery must be handled correctly to avoid possible danger. If you replace the battery, you must adhere to all safety instructions.

About this task

Use this procedure to replace a CMOS battery. Dispose of the faulty battery properly.
CAUTION:
If your system has a module containing a lithium battery, replace it only with the same module type made by the same manufacturer. The battery contains lithium and can explode if not properly used, handled, or disposed of.
Do not:
  • Throw or immerse into water
  • Heat to more than 100°C (212°F)
  • Repair or disassemble
Dispose of the battery as required by local ordinances or regulations. (C045)

Procedure

  1. Complete Procedure: Removing a Storwize V7000 Gen2 node canister
  2. Open the canister and remove the lid as described in Procedure: Removing and replacing the lid of a Storwize V7000 Gen2 node canister.
  3. Locate the CMOS battery inside the node canister. Figure 1 shows an example,
    Figure 1. Replacing a CMOS Gen2 battery
    Replacing a CMOS Gen2 battery
  4. Push the coin cell latch to the side to release the coin cell from its holder, then remove the expired coin cell.
  5. Orient the replacement coin cell with the flat side upwards and place it down onto the coin cell holder.
  6. Gently push the coin cell down into the holder so that it clicks under the latch and sits parallel with the canister main board.
  7. Replace the canister lid as described in Procedure: Removing and replacing the lid of a Storwize V7000 Gen2 node canister.
  8. Reinsert the canister into the slot from which it came.
  9. Reconnect all cables.
  10. Open the management GUI.
  11. Use the management GUI to check that the time and date settings of the system are correct.
  12. In the event log view, if a CMOS battery error is present, run the fix procedure.