LOAD RESTART/TERMINATE was not performed on the targeted partitions because they were not
in LOAD PENDING state
Explanation
The connector attempted to restart or terminate a bulk load on a table that is not in the
LOAD PENDING state. If the table is partitioned, at least one of the partitions was not in
the LOAD PENDING state. The connector will attempt to restart or terminate a load if the
Usage > Load control > Load mode property is set to Restart or Terminate. The connector will
also attempt to terminate a load if the Usage > Load control > Clean-up on failure property
is set to Yes.
User response
If the Usage > Load control > Load mode property is set to Restart or Terminate, verify the
table is in LOAD PENDING state. If the table is partitioned, verify whether all partitions
are in LOAD PENDING state. If the Usage > Load control > Clean-up on failure property is set
to Yes, then this message is simply informational. If this message is not desired, manually
move all partitions to the desired state and re-run the job.