Changing a delayed fallback timer policy

Edit online

You can use SMIT to change or show a delayed fallback timer policy.

About this task

To change or show a previously configured fallback policy, complete the following steps:

Procedure

  1. From the command line, enter smit sysmirror
  2. In SMIT, select Cluster Applications and Resources > Resource Groups > Configure Resource Group Run-Time Policies > Configure Delayed Fallback Timer Policies > Change/Show a Delayed Fallback Timer Policy and press Enter.
  3. Select the fallback timer policy to change.
  4. Change the fallback timer policy on the next panel.

Results

The new value for the timer will come into effect after synchronizing the cluster and after the resource group is released and restarted (on a different node or on the same node) due to either a cluster event or if you move the group to another node.

Note that you can change the parameters, but you cannot change the type of recurrence for the specific fallback timer. However, you can configure another fallback timer policy that uses a different predefined recurrence, and assign it to a resource group.