Disable administration security
to remove control over an integration node and its resources.
About this task
You can disable administrative security
for an integration node by updating the relevant integration node property.
Procedure
-
Stop the integration node
by
running the mqsistop command.
-
Clear the security option for this integration node
by
running the mqsichangebroker command,
specifying the parameter -s inactive.
For example, to disable security for the integration node
IBNODE, enter the following
command:
mqsichangebroker IBNODE -s inactive
-
Start the integration node
by
running the mqsistart command.
Results
When this command completes, all users
are able to complete tasks against the integration node; for example, they can
run the mqsichangeproperties command
to change integration node properties. They can also complete all tasks against
all integration servers that have been defined, and are defined in the
future, on this integration node.When you disable integration node administration security,
the authorization queues that are associated with this integration node are
retained. If you enable security again, these queues are reused, therefore
you must ensure that the authorizations defined by these queues are
correct.