You can add an XML wire format
physical format layer to a message set by using the Message Set editor.
Before you begin
You
must have completed the following tasks:
About this task
This task topic describes how to
add an XML wire format physical format layer to a message set using
the Message Set editor.
To add an XML physical format layer
to a message set:
Procedure
- Switch to the Integration Development
perspective.
- In the Message Set editor, in the Properties Hierarchy,
open the Add XML Wire Format window by right-clicking XML
Wire Formats, then clicking Add XML Wire Format on
the pop-up menu.
- On the Add XML Wire Format window,
specify the name that you want to use for the new XML wire format.
The default name is 'XML1'.
Tip: Physical format
names must be unique across a message set. You are recommended to
start the name of your new XML physical format with 'XML', because
this clearly identifies the type of the physical format that you are
adding in relation to any of the other types.
- Click OK to add the physical format
layer. Alternatively, if you decide to cancel the process, click Cancel or
press Esc on the keyboard.
Tip: The new physical
format layer is added with the relevant default property values. You
can configure the message set properties according to your requirements,
using the appropriate editor.
- Save your changes either by clicking File> Save or
by pressing Ctrl+S.