Adding an input terminal to a Collector node for each input source

Add new dynamic input terminals to the Collector node for all of the sources of messages for your message collections.

Before you begin

This task assumes that you have already created a message flow that contains a Collector node. For more information, see Creating a flow that uses message collections.

About this task

To add a dynamic input terminal to the Collector node for each message source, complete the following steps.

Procedure

  1. Right-click the Collector node and select Add Input Terminal.
  2. In the dialog box that is displayed, enter a name of your choice for the terminal, and click OK.
    The name that you give to the input terminal is used as the folder name in the message collection.
  3. Repeat steps 1 and 2 to add further input terminals.

What to do next

When you have created all the required input terminals on the Collector node, you can set the event handler properties. For more information see, Setting event handler properties.