After installation of the JBoss agent, you must configure it before you start
the agent. If the JBoss agent is installed
on a local Linux® or UNIX computer, you can follow these instructions to configure it interactively through command
line prompts.
About this task
Remember: If you are reconfiguring a configured agent instance, the value that is set in
the last configuration is displayed for each setting. If you want to clear an existing value, press
the space key when the setting is displayed.
Procedure
-
On the command line, run the following command:
install_dir/bin/jboss-agent.sh config instance_name
where install_dir is the path where the agent
is installed and instance_name is the name that you want to give to the agent
instance.
Example
/opt/ibm/apm/agent/bin/jboss-agent.sh config example-inst01
-
Respond to the prompts to set configuration values for the agent.
-
Run the following command to start the agent:
install_dir/bin/jboss-agent.sh start instance_name
where install_dir is the path where the agent
is installed and instance_name is the name of the agent instance.
Example
/opt/ibm/apm/agent/bin/jboss-agent.sh start example-inst01